2003 Hot Products Catalog

FUEL SYSTEMS EXHAUST DRIVE LINE HANDLING ELECTRICAL WATERLINE/ BILGE STEERING & CONTROLS SERVICE TOOLS /HARDWARE CHEMICAL BODY ACCESSORIES ENGINE/ GASKETS 59 CATALYTIC CONVERTER REMOVAL PLATE FOR YAMAHA GPR This plate allows you to remove the catalytic converter easily and fills the gap where the catalytic converter mounts on the OEM exhaust system. Benefits include a cooler running exhaust system and ability to run any kinds of two- stroke oil. The plate features a centrally located outlet designed to give some beneficial back pressure but with much better exhaust gas flow compared to an offset or cutout plate. This gives better response and acceleration throughout the power band. Part No. YE-155P 332-12000 Description JetWorks Catalytic Converter Removal Plate R&D D-Plate JETWORKS FLOW CONTROL VALVE The Flow Control Valve provides improved throttle response and much quicker starts by drying out your waterbox at low rpm and idle speeds. Tests have shown an average acceleration improvement of 10 feet over a non-equipped model in the first 50 feet. The Flow Control Valve allows unrestricted water flow to the Stinger for better top speed.Yet it controls the amount of water at low speeds for better response. It also allows for an easier tuning of the Carburetors. It does not interfere with normal engine or exhaust pipe cooling and is compatible with all electronic water injection systems. Race Legal for All Classes.Two Models are available. Both are adjustable. The Standard Flow Control Valve is preset at 3.5 p.s.i. and is adjusted by adding the supplied stainless steel shims to increase the spring tension. The Pro-Series is externally adjustable by turning the outer housing by hand. Pressure can be tested with pop off gauge. All PWC w/OEM or aftermarket exhaust systems (except Yamaha’s w/OEM exhaust) Part No. 52-3118 52-3119 52-3122 Description Standard Flow Control Valve 3/8” Pro Flow Control Valve 3/8” Pro Flow Control Valve 1/4” RIVA EXHAUST STINGER WATER FILTER/RESTRICTOR Features fine mesh stainless filter screen that is threaded to accept Mikuni main jet (not included) for water restriction. Allows removal of restrictive filter screen in water distribution manifold of single, twin and triple exhaust systems, providing increased cooling water to motor. Part No. RY15-SF38 Description Exhaust Stinger Water Filter/Restrictor 3/8” JETWORKS QUICK DISCONNECT WATER RESTRICTOR QD-38 comes with 4/3/2mm restrictor inserts used for controlling water flow through exit passes, stinger, head pipes, etc. QD-14 is for use with Mikuni Jets (not included), and allows quick change in small increments of water flow. Part No. QD-38 QD-14 Description Quick Disconnect Water Restrictor 3/8” Quick Disconnect Water Restrictor 1/4” RIVA Cat Temp Sensor Chip is a must when removing the OEM catalytic converter on Yamaha GP1200 Powervalve engines. The circuit is designed to mimic the signal sent to the OEM CDI by the catalytic converter’s temperature probe preventing CDI, flutters, warning devices and engine shut downs due to cat removal. Can be used with stock or modified OEM CDI’s. Plugs directly into factory wire harness. Description Part No. Cat Temp Sensor Chip Yamaha 1200 Powervalve (66V) RY115-20 RIVA CAT TEMP SENSOR CHIP FOR GPR QD-14 QD-38