2018 Hot Products Catalog

HotProductsUSA.com • Orders & Info: 858-453-4454 95 WAVEBLASTER CONVERSION INTAKE SYSTEMS ENGINE/ GASKETS EXHAUST DRIVE LINE HANDLING ELECTRICAL WATERLINE /BILGE STEERING & CONTROLS BODY ACCESSORIES SERVICE TOOLS /HARDWARE CHEMICAL © 2018 Hot Products. All rights reserved. WAVEBLASTER CONVERSION ADA BILLET ENGINE MOUNT YAMAHA 3 CYL CONVERSION TO WAVE BLASTER Billet engine mount brackets to allow the Yamaha 1100/1200 (non-power valve) engine to drop right into a WaveBlaster. Sets the rear of the engine in the same spot as the stock, so you still use the stock mid-shaft. Only modification required is to remove the waterbox and grind part of the rib from the waterbox tray. Description Part No. Billet Engine Mount 34-550190 HIGH SPEED INDUSTRIES WAVEBLASTER HULL EXTENSION KIT Fiberglass hull extension kit for 1993-96 Yamaha Waveblaster 1. Hull extensions add 4” of surface to the bottom of the hull, which drastically improves handling on the race course. The extension kits come in two versions. Full length (full 4” length) and Sport Spec (4” with relief cut). The full length extensions come with a cut line marked on them if you wish to cut them down to sport spec size. These extensions will fit all ride plates. Installation instructions and hardware are included in the kit. After installation it is recommended that you true the hull and extensions together for the best results. Description Part No. Sports Spec Hull Extension - White HSI01-WHT Sports Spec Hull Extension - Black HSI01-BLK Full Length Hull Extension - White HSI02-WHT Full Length Hull Extension - Black HSI02-BLK PROWATERCRAFT WAVE BLASTER FRONT SPONSONS Description Part No. Wave Blaster 1 PW-SP-260-HFC PROWATERCRAFT HULL EXTENSIONS Description Part No. Wave Blaster 1 PW-03B-7000 RHAAS BLASTER ENGINE SETBACK KIT Setback kit for Blaster twin cylinder motor. This kit allows you to move the motor back 1” - 1 1/4”. You can use a custom midshaft to move back 1 1/4’ or use a GP760 midshaft and move the motor back 1”. Helps to give the boat a little change in attitude and helps getting the nose up for freestyle. Includes motor plates, motor mounts and all hardware to make the swap. Uses oem #65v-51323-00-00 mid- shaft or WSM 003-257 coupler shaft. Description Part No. Blaster Engine Setback Kit BLASTBACK UMI WAVEBLASTER STEERING SYSTEM The UMI system has been updated to include these new features: • 1” taller steering head height • Steering head now accepts both standard (7/8”) and fat bars (1-1/8”) • The system is now anodized black • Adjustable Quick steering arm * The steering arm is also offered separately for upgrading original UMI Blaster Steering systems. Description Part No. UMI Steering System YA-04700-TS-17 Steering ArmUpgrade YA-04700-TS-ARM-17 Steering Cable Bracket 34-510090 (6mm Cable) JCRACING WAVE BLASTER PUMP SETBACK KIT 50mm (2 inch) setback pump kit for Yamaha Wave Blaster B1. Description Part No. Wave Blaster B1 JCR-100-SET Setback Pump Kit JCRACING MID & REAR SPONSONS Description Part No. Mid Sponsons JCR-1020-SET Rear Sponsons JCR-1009-SET JCR-1020-SET JCR-1009-SET EXTREME THROTTLE YAMAHA WAVE BLASTER HOOD SEAL Description Part No. Wave Blaster Hood Seal EXB1SEAL