225
FOUR
STROKE
INTAKE
SYSTEMS
ENGINE/
GASKETS
EXHAUST
DRIVE LINE
HANDLING
ELECTRICAL WATERLINE
/
BILGE
STEERING
&
CONTROLS
BODY
ACCESSORIES
SERVICE TOOLS
/
HARDWARE
CHEMICAL
©2013 Hot Products. All rights reserved.
3”
(80
mm)
I.D. 1”
(25
mm)
Part No.
57-4050
57-4060
A2265
57-4055
Description
A
.
All Sea-Doo (Except XP)
All Sit down Yamaha / Kawasaki*
B
.
Universal (Complete System)
C.
Drain Plug Only
Sea-Doo (95 and newer), Polaris, and Honda
Duck Bill Flapper only
B.
DUCK BILL DRAIN SYSTEM
Simple and clean, drains water from hull under acceleration.
A.
Add to your current drain plug
or
B.
Purchase entire system kit.
A.
*
Kawasaki models require slight modification
BILLET QUICK DRAIN FOR KAWASAKI
Mounts to the transom of your Kawasaki 1200 STX-R or SX-R 800
watercraft with billet aluminum mounting plate.
Kawasaki
Part No.
1200
STX-R, 800 SX-R
57-4065
UNIVERSAL BILLET QUICK DRAIN
Mounts to the transom of any watercraft with billet aluminum mounting plate.
Description
Part No.
Billet Quick Drain Kit
57-4059
C.
DUCK BILL DRAIN ADAPTER PLUG
Unscrew stock drain plug and screw our duck bill drain plugs in place. Keep
your stock plug if you ever need to change!
Description
Part No.
D.
Kawasaki
Z471
E.
Yamaha
Z472
D.
E.
RICK ROY
PRODUCTS
SCUPPER VALVE
Description
Part No.
RRP Scupper Valve
RRP-SCU-V
BILGE SPONGE
This Viscose-Covered sponge will pick up
and hold an amazing 32 ounces (512gm) of
water without leaking. With grommet and
hand cord.
Description
Part No.
Bilge Sponge
57-4070
BLOWSION CAS BILLET
ALUMINUM ONE WAY VALVE SCUPPER
The new CAS flow valve design prevents water getting in during tail stands,
wave jumping, or all out buoy shredding. The new billet flange assembly is
the premium design setup and allows use of the Blowsion billet exhaust
outlet so vain riders can sanitize both sides of the rear of their watercraft.
The aluminum, rubber, and injection molded construction of the Blowsion
one-way valve assembly along w/ the recessed internal mounting results in
a bulletproof set-up.
Fits all years Super Jet, Kawasaki 650, 750, 800 SXR
and Polaris Octane.
Each pre-assembled kit includes explicitly detailed
instructions, two Blowsion molded glue able urethane bulkhead and ski
flanges for leak less sealing, recessed one-way flow valve, special flex
tubing (allows for off center mounting unlike straight PVC tube scupper
systems) mounting epoxy and stainless fasteners.
Description
Part No.
Blowsion CAS Aluminum One Way Valve Scupper
06-01-022
BLOWSION ONE
WAY VALVE
Unlike scupper valves that
mount on the exposed exterior
of your ski, Blowsion one way valve kits install “into” the rear 1/4 of your
PWC end caps. This keeps continual water pressure on the inside of the
tube, keeping the valve shut when the ski is floating.
Description
Part No.
Pro Finish Kit
06-01-028