FUEL
SYSTEMS
EXHAUST
DRIVE LINE
HANDLING
ELECTRICAL WATERLINE/
BILGE
BODY
SERVICE TOOLS
/
HARDWARE
CHEMICAL
HANDLEBARS
&
CONTROLS
ACCESSORIES
ENGINE/
GASKETS
55
JETWORKS FLOW CONTROL VALVE
The Flow Control Valve provides improved throttle response and much quicker
starts by drying out your waterbox at low rpm and idle speeds. Tests have shown
an average acceleration improvement of 10 feet over a non-equipped model in the
first 50 feet. The Flow Control Valve allows unrestricted water flow to the Stinger for
better top speed. Yet it controls the amount of water at low speeds for better
response. It also allows for an easier tuning of the Carburetors. It does not interfere
with normal engine or exhaust pipe cooling and is compatible with all electronic
water injection systems. Race Legal for All Classes.Two Models are available. Both
are adjustable. The Standard Flow Control Valve is preset at 3.5 p.s.i. and is adjust-
ed by adding the supplied stainless steel shims to increase the spring tension. The
Pro-Series is externally adjustable by turning the outer housing by hand. Pressure
can be tested with pop off gauge. All PWC w/OEM or aftermarket exhaust systems
(
except Yamaha’s w/OEM exhaust)
CATALYTIC CONVERTER REMOVAL
PLATE FOR YAMAHA GPR
This plate allows you to remove the catalytic converter easily and fills the gap
where the catalytic converter mounts on the OEM exhaust system. Benefits
include a cooler running exhaust system and ability to run any kinds of two-
stroke oil. The plate reatures a centrally located outlet designed to give some
beneficial back pressure but with much better exhaust gas flow compared to an
offset or cutout plate. This gives better response and acceleration throughout
the power band.
Part No.
52-3118
52-3119
52-3122
Description
Standard Flow Control Valve
3/8”
Pro Flow Control Valve
3/8”
Pro Flow Control Valve
1/4”
Part No.
YE-155P
332-12000
Description
JetWorks Catalytic Converter Removal Plate
R&D D-Plate
SOLENOID
The electronic Switch that pulses
the water to the spray nozzle.
Part No.
30-00-5515
WATER FILTER
A clear bowl & removable filter
screen allow easy inspection &
cleaning. 3/8” Inlet.
Part No.
56-9011
REMOTE MOUNT
SPRAY NOZZLE
The brass 1/16” NPT spray nozzle
that attaches to an 1/8” hose from
the solenoid.
Part No.
30-00-5520
REMOTE MOUNT
SPRAY NOZZLE
The brass 1/8” NPT spray nozzle
that mounts to the solenoid.
Part No.
30-00-5521
MSD PWM WATER CONTROL SYSTEM
TRIPLE
This system uses three separate solenoids & spray fitting to inject water at three
different points & settings to achieve complete control & performance.
Description
Triple Channel Water Control System
Triple Channel Control Unit Only
Part No.
30-00-2081
30-00-5510
SINGLE
Designed to mount in a variety of stock & aftermarket exhaust systems
with a single injection point.
Description
Single Channel Water Control System
Single Channel Control Unit Only
Part No.
30-00-2080
30-00-5505